Free shipping
Save 50%

XTOOL D1 / ELEGOO Laser Rotary Selector Switch

Write a review
List price: $50.00
$25.00
You save: $25.00 (50%)
Top Mount means you're mounting it on the top of the Frame, bottom mount means you're mounting it under the frame.
MiniSlideSwitch
In stock
+

UPDATE: COMPATIBLE WITH ELEGOO LASER AS TESTED BY COBEY SCHMIDT-LASER GURU! IF YOU HAVE THE XTOOL RA2 IT'S PLUG AND PLAY, OTHERWISE YOU MAY NEED SOME 4PIN FEMALE TO 6PIN FEMALE STEPPER MOTOR WIRES (THATS STANDARD CONFIG)

STOP HAVING TO DISCONNECT THE YAXIS FROM THE MOTHERBOARD JUST SO YOU CAN USE YOUR ROTARY!!!!  WHY TAKE THE CHANCE ON BREAKING THE CONNECTOR?

JUST UNPLUG THE YAXIS FROM THE MOTHERBOARD AND PLUG IT INTO THE SWITCH. CONNECT THE SMALL CONNECTOR ON THE SWITCH TO THE MOTHERBOARD AND THEN YOU CAN PLUG IN UP TO 2 ROTARIES IN EITHER THE ONE LABELED "ROTARY" OR THE ONE LABELED "CHUCK" (THEY BOTH FUNCTION THE SAME)

  Has 4 connectors, 2 for rotary accessories, 1 for the "Y" axis and 1 to connect to the mother board where the "Y" access was connected.

IMPORTANT: THIS WORKS WITH THE D1 PRO AND IF YOU HAVE THE ORIGINAL D1 AND 2 ROTARIES YOU CAN USE IT TO SWITCH BETWEEN THE TWO ROTARIES. ALLOWS HAVING 2 ROTARIES ON THE D1 PRO ALSO. ie: I have the original Rotary and the RA2. I leave the RA2 in chuck configuration. 

Jim Sutton
Advantages
Mathew, I decided to order your switch and received it today. It is very welll made and yes, it works. Nice color (red) match for my Xtool. You did good, thank you!
Comment
Buy it!
Administrator reply
Thank you so much for taking the time to post your review!